Home › Brand Directory › Cisco
Hardware Engineering Reference (2026 Edition)

Cisco Router Admin Login & Default Credentials

Complete technical setup guide for Cisco networking equipment. Access your gateway dashboard at 192.168.1.1 or https://192.168.1.1, retrieve verified credentials, and configure Wi-Fi security.

Quick Answer: How to Log Into Any Cisco Router

Connect your device to your Cisco Wi-Fi network (SSID format: CiscoSB_XXXX) or connect an Ethernet cable to LAN Port 1. Open any web browser and go to https://192.168.1.1 or http://192.168.1.1. Enter factory default username cisco and password cisco.

Live Gateway Diagnostic Console
Console Idle

Test whether your device is currently connected to a Cisco gateway at 192.168.1.1 or https://192.168.1.1 directly from your browser.

Open 192.168.1.1 Dashboard →

Cisco Router Models & Default Credentials

Verified factory default IP addresses, admin usernames, and passwords for Cisco hardware:

Swipe left/right to view all columns →
Hardware Model Default Gateway IP Default Username Default Password Technical Notes
Cisco
Small Business RV340, RV260, RV160
https://192.168.1.1
 cisco cisco Enforces HTTPS; password must be changed immediately upon initial login.

Step-by-Step Cisco Admin Setup Guide

1

Connect to Cisco Local Network

Connect your PC, smartphone, or tablet to the router network via Wi-Fi (SSID format: CiscoSB_XXXX) or plug an Ethernet patch cable into any numbered LAN port (1 through 4). Avoid connecting to guest networks.

2

Launch Browser & Enter Gateway IP

Open Chrome, Safari, Firefox, or Edge. In the top URL address bar, enter https://192.168.1.1 or http://192.168.1.1 and press Enter.

3

Input Factory Admin Credentials

When prompted by the authentication dialog, enter default username cisco and password cisco. If these fail, check the printed serial label underneath your device or perform a hardware reset.

4

Update Admin Password & Configure Wi-Fi

Immediately navigate to Administration / System Settings and replace the default password with a cryptographically secure key. Proceed to Wireless Settings to configure WPA3-Personal security.

How to Factory Hard Reset a Cisco Router

If you forgot your customized admin password or experience firmware corruption, you can restore factory defaults using the physical hardware reset procedure:

Important Notice: Configuration Erasure

A factory reset permanently erases all customized Wi-Fi network names (SSIDs), passwords, port forwarding rules, static DHCP reservations, and custom DNS settings. Your router will revert to factory defaults.

  1. Verify your Cisco router is plugged in and the Power LED light is solid.
  2. Locate the recessed Reset pinhole button on the rear or bottom panel.
  3. Insert an unfolded paperclip or SIM-ejection tool and press the button firmly for 10 to 15 seconds.
  4. Watch the LED indicator lights blink, indicating the flash memory reset sequence has initiated.
  5. Release the button and allow 2 to 3 minutes for the system to complete its automated reboot cycle.
  6. Reconnect using factory default credentials: username cisco and password cisco.

Frequently Asked Technical Questions

Cisco RV series routers (RV340, RV260, RV160) default to 192.168.1.1. Most modern Cisco devices enforce HTTPS, so navigate to https://192.168.1.1 in your browser.

The factory default username is 'cisco' and the default password is 'cisco' (or 'admin' / 'admin'). Cisco firmware requires changing this password upon first login.

Cisco routers use a self-signed local SSL certificate for HTTPS encryption. In Chrome or Safari, click 'Advanced' and choose 'Proceed to 192.168.1.1 (unsafe)' to open the dashboard securely.

Locate the Reset button on the back panel. While the router is powered on, use a pin to hold the button for 10 to 15 seconds until the Power LED blinks amber, then release.