Fiber ONT Setup & ISP Gateway Bridge / IP Passthrough Guide
Optical fiber connections (AT&T Fiber, Verizon Fios, Google Fiber, CenturyLink Quantum) terminate at an Optical Network Terminal (ONT) or combo gateway. Using your own ASUS, Netgear, Ubiquiti, or TP-Link router behind a carrier box requires enabling IP Passthrough or Bridge Mode so your personal router gets the public IP directly.
| Fiber / ISP Provider | Common Hardware | Console IP | Recommended Bypass Method |
|---|---|---|---|
| AT&T Fiber | BGW320-500 / BGW210 | 192.168.1.254 |
IP Passthrough (DHCPS-fixed): Passes public IPv4 cleanly to your router’s WAN MAC address. |
| Verizon Fios | CR1000A / G3100 | 192.168.1.1 |
Direct ONT Ethernet: Internet-only plans can plug Ethernet straight from the Nokia/Calix ONT into your own router. |
| CenturyLink / Quantum | C4000XG / C5500XK | 192.168.0.1 |
Transparent Bridging + VLAN 201: Requires setting 802.1Q VLAN ID 201 on your personal router’s WAN interface. |
| Xfinity xFi | XB6 / XB7 / XB8 | 10.0.0.1 |
Gateway Bridge Mode: Toggle under Gateway › At a Glance › Bridge Mode (after enabling Admin Tool in Xfinity App). |
How to Configure AT&T Fiber BGW320 IP Passthrough
- Open
http://192.168.1.254and navigate to Firewall › IP Passthrough. - Enter the Device Access Code printed on the rear/side label of the BGW320.
- Set Allocation Mode to Passthrough and Passthrough Mode to DHCPS-fixed.
- Choose your personal router’s MAC address from the Passthrough Fixed MAC Address dropdown and click Save.
- Navigate to Home Network › Wi-Fi and turn off the BGW320 2.4 GHz and 5 GHz radios so they do not compete with your personal router.
- Reboot your personal router; its WAN port should now lease your live public IPv4 address directly.
FAQs
What happens if I don't enable Bridge Mode when plugging in my own router?
Both routers perform Network Address Translation (Double NAT), which commonly breaks console multiplayer, self-hosted VPNs, and remote access while causing Wi-Fi channel interference if the ISP Wi-Fi stays enabled.
Should I turn off Wi-Fi on the ISP gateway after enabling IP Passthrough?
Yes. Disabling the ISP box's built-in 2.4 GHz and 5 GHz radios prevents overlapping wireless interference and ensures devices only connect through your personal router.
The Bottom Line
To use your own router cleanly behind ISP fiber or cable hardware, enable IP Passthrough or Bridge Mode inside the carrier gateway console and turn off the carrier box's Wi-Fi radios.
Default Gateway Directories & Subnets
Access login sheets and diagnostic consoles for major RFC 1918 private gateway subnets:
Router Manufacturer Portals
Browse factory default credentials, setup guides, and model databases by brand: